The original Honey Bee was a great helicopter;
The Honey Bee Mark 2 builds on that heritage and adds many improvements that make flying a helicopter easier.
Ready to fly within minutes of opening the box. Install 8 AA cells (not included) in the transmitter,
charge the flight pack and you are ready to FLY.
If you are a novice, leaving the flybar weights at the outer position will dampen the
controls and make the helicopter more docile.
As you improve, move the weights in for quicker response.
The tail boom is about 1-1/2" longer for more stable control.
The swashplate has a metal ball for reduced wear and more precise control and the servos are screwed to the frame for solid response.
Main rotor has a fiberglass plate that reduces blade coning and improves the helicopters forward flight characteristics.
Main and tail rotors are fixed pitch and controlled by individual motors.
The installed mixing board controls mixing of the main and tail rotors.
The board also contains 2 speed controls, a peizo gyro for tail stabilizing and a
BEC circuit that supplies power to the receiver and servos.
A 7 cell 650 mAh NiMH battery and wall charger is included.
Ready to Fly RTF out of box except 8 "AA" battery(not include), and is TESTED by US !!


Main rotor diameter: 520mm
Weight: 290g
Length: 510mm
Power system: 370motor
KIT/ARF/RTF: RTF/KIT
Control mode: normal
Transmitter: standard 4 CH
Mix controller: 4in1 controller(W/Gyro,mixer,ESC,receiver)
Servo: 8.0g,1.3kg/CM,0.13S/60
Battery: 8.4V-650mAh Ni-MH